Good first Trimix experience, but questions remain . . .

Melody68

Active Member
Hey guys, I'm 69 and on TE for a year. Been on Viagra about 10 years, but it's really not cutting it anymore. Just had my first 25/20/1 Trimix experience, thank you Nelson Vergel for your excellent instruction. Can somebody guess where my final dose will end up?

I've always had a good response to small doses of any medication (T included); I wanted to try a really small dose of Trimix so that I don't end up in emergency. I decided to go with .035ml, not expecting much of anything. I managed to find a pack of 10 BD insulin needles, 30 G, .5ml barrel, 5/16" long. I had removed the Trimix vial from the freezer last night and put it in the fridge. I filled 3.5 units (.035ml), capped the needle and returned the vial to the fridge. Walking back I was starting to feel a little anxious about injecting. I tried to massage a bit of size into my member, but it remained at a shriveled low; I'm sure it knew what was coming. However, I found a good spot, wiped with the alcohol pad and then injected without thinking about it. Once in I was going to push the plunger slowly, but at first it wouldn't move, and then suddenly it gave way and quickly emptied the barrel. Was I just barely through the Corpus Cavernosum . . . maybe I should use a longer needle? Anyway, it was in and not painful at all.

I take a blood thinner, so I held an alcohol pad on it for 5 minutes while massaging up and down. No bruising, and no pain through the whole thing. About two minutes later, to my surprise, my penis started filling up. At 10 minutes in I had a soft erection, maybe 5.5 out of 10; remarkable for such a small dose; I didn't think it would go anywhere. At 13 minutes in, I was about at where Viagra gets me, let's say a 6.5 out of 10. I was by myself; at 15 minutes in I was still at a 6.5 erection so I decided to watch some porn. Ten minutes later I was done, had quite a headache afterwards which dissipated in about 3 minutes (anyone know what that's about?). Penis softened 4 minutes later and was full but bendable after 7 minutes. Now is 1/2 hour after finishing, still full but completely bendable.

Quite remarkable; basically that very small dose gave me everything that 50mg of Viagra currently does. Of note were my three concerns; the needle length, the headache, and what dose I try next to eventually hit a 9/10 erection. Any thoughts?
 
Last edited:
Try 0.10 ml. Your dose was too low. I use 0.12 ml. I use a 27 gauge 1/2 inch but the length depends on your girth.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.
 
Try 0.10 ml. Your dose was too low. I use 0.12 ml. I use a 27 gauge 1/2 inch but the length depends on your girth.

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.
Thanks Nelson. I'm surprised you use a 27g needle to inject Trimix: I use a 27g to inject my T, which is much thicker than the Trimix. Isn't the idea to use the smallest gauge possible when injecting the penis? Do you notice a greater pain level with the wider needle?

I don't think I'm a particularly girthy guy, and I took some comfort in accepting the smaller 5/16" long needle when considering Trimix. However when I first tried to inject, I sunk the needle all the way in until it reached the hub, but the plunger wouldn't depress. It's only when I pushed the hub even further into the skin that the plunger suddenly and quickly gave way. Does that mean that I'd be better off with the 1/2"?
 
Well I did round two with Trimix with a very conservative 5 unit dose; it wasn't much different at all from the 3.5 unit dose that I did a couple of days ago, leaving me with a 7/10 erection that lasted about 40 minutes. That leads me to believe that I'll ultimately need 10-12 units or more to get where I want to be, which is a 9/10 erection. I hope it's possible.

I have tremendous concern with needing to go to Emergency with the hard-on from hell, so I'm opting for slow and go with my doses.

With regard to needle length, the experience was also much the same - I did the left side, slid in the 5/16" 30g needle and got resistance from the plunger. Pushing in further, so that the needle hub dramatically dimpled the skin, the plunger suddenly gave way. I figure I need the longer 1/2" needle. Now I'm quite an average sized guy, maybe just a bit more girthy, but not when flaccid. I'd think that most men would make a better bet by starting with the 1/2" needle. I've read that you don't have to push the 1/2" needle all the way in; you can leave 1/16" inch of the needle shaft (thickness of a dime) still showing near the hub. I've ordered some BD 29g 1/2" .5ml needles. I think they'll work well - the .5ml barrel is much easier to visualize the numbers, and BD's always seem exceptionally sharp. Will try injecting again on Friday, with 7-8 units.
 
Last edited:
I use 30 ga 5/16” needles. Nelson is correct they do bend easily. It has happened while sticking through then vial rubber stopper.
I started with .05 mil and got a little chubby. Went to .08 and then .10 ml. I now use .20 and if the vial is a couple months old I go up to .25. Still do not get a hold the towel up erection, but enough for food penetration.
 
I use 30 ga 5/16” needles. Nelson is correct they do bend easily. It has happened while sticking through then vial rubber stopper.
I started with .05 mil and got a little chubby. Went to .08 and then .10 ml. I now use .20 and if the vial is a couple months old I go up to .25. Still do not get a hold the towel up erection, but enough for food penetration.
Hey Mooseman, thanks for the commentary. Both my first two Trimix's thus far were with the 30g 5/16" needle. I tried bending the needle today on a scrap piece of wood and was shocked how easily it bent. Then I bent back and forth a few times and it snapped off.

Really I haven't read of anybody snapping a needle while injecting, but it still helped convince me to go with the 29g needle. In fact, if you want a 1/2" long needle, then I don't think you have any choice but the bigger diameter; they don't make a 30g 1/2" needle, except for animal vets.

Interesting what you said about your doses. Is it true that the more Trimix that you take, the harder you get, but at the expense of remaining longer and longer in the erection time period? I've heard that some get an erection described with colourful phrases like "stiff enough to hang a towel on it" and "hard enough to pound concrete nails" (ha!). But maybe that's not everybody, no matter how much they take?
 
Last edited:
I use 30 ga 5/16” needles. Nelson is correct they do bend easily. It has happened while sticking through then vial rubber stopper.
I started with .05 mil and got a little chubby. Went to .08 and then .10 ml. I now use .20 and if the vial is a couple months old I go up to .25. Still do not get a hold the towel up erection, but enough for food penetration.
I just made the dumbest f'n error in judgment by using my 30 ga when it was a little bent. I figured oh it'll still get in there. Luckily, it didn't break, but not a damn bit of it made it where it was supposed to go.
 
Hey Mooseman, thanks for the commentary. Both my first two Trimix's thus far were with the 30g 5/16" needle. I tried bending the needle today on a scrap piece of wood and was shocked how easily it bent. Then I bent back and forth a few times and it snapped off.

Really I haven't read of anybody snapping a needle while injecting, but it still helped convince me to go with the 29g needle. In fact, if you want a 1/2" long needle, then I don't think you have any choice but the bigger diameter; they don't make a 30g 1/2" needle, except for animal vets.

Interesting what you said about your doses. Is it true that the more Trimix that you take, the harder you get, but at the expense of remaining longer and longer in the erection time period? I've heard that some get an erection described with colourful phrases like "stiff enough to hang a towel on it" and "hard enough to pound concrete nails" (ha!). But maybe that's not everybody, no matter how much they take?
For me the increased amount has not translated to harder erection, to my dismay. I was really hoping that it would five me rock hard erections but no such luck. Same with length of time. After ejaculation myndick will loose stiffness, It can be worked back up to enough for penetration. I meet with Defy Dr next week and will ask thoughts about going higher on dosage. I keep a vial of the drug to bring erection down, phenyl…… something.
We are all different in how meds react
 
I just made the dumbest f'n error in judgment by using my 30 ga when it was a little bent. I figured oh it'll still get in there. Luckily, it didn't break, but not a damn bit of it made it where it was supposed to go.
Ha, I have never tried injecting a bent needle in my dick, it has crossed my mind though lol. I have injected bent needle in belly. Really dumb in light of what Nelson said
 
I just made the dumbest f'n error in judgment by using my 30 ga when it was a little bent. I figured oh it'll still get in there. Luckily, it didn't break, but not a damn bit of it made it where it was supposed to go.
Really I'm hating all this talk about broken needles, especially in my dick. You would think that if it did break you could retrieve it with some tweezers (I'll now keep tweezers on hand when I inject), but you'd have to have the presence of mind to keep it together . . . and if it migrates somewhere else then we're truly f*cked.

Really, I'm tempted to experiment with bigger gauge needles, but of course then there's a less than desirable counterargument to doing so. Judging from my T injections, a 25g needle is quite solid as probably is a 27g but who (except Nelson) has the nerve to push those into your manhood? Hmmm . . .
 
For me the increased amount has not translated to harder erection, to my dismay. I was really hoping that it would five me rock hard erections but no such luck. Same with length of time. After ejaculation myndick will loose stiffness, It can be worked back up to enough for penetration. I meet with Defy Dr next week and will ask thoughts about going higher on dosage. I keep a vial of the drug to bring erection down, phenyl…… something.
We are all different in how meds react
Even though I'm very early in the Trimix game, I'm kind of fearful that it'll give me an "adequate" erection, but also won't knock my socks off. I probably feel like that because I've read about those lucky users who've had super rigid erections, and frankly I'd like to surprise my wife with that. Could a doctor correct that by altering the Trimix formula? Please keep in touch with what the Defy Dr. says . . .
 
Ok, tried Trimix for the third time, this time with 8 units. The first two times were with the shorter 5/16" 30g needle, and they only worked when I pushed the needle in extra hard, so I thought I'd try a longer 1/2" 29g needle. The 29g is OK, no extra pain, but . . . it didn't work, I must have missed the CC. I put the needle in, sunk it up to the hub, and then couldn't depress the plunger, so I figured I went too far. I pulled it out a bit and was able to push the plunger, but it wasn't as easy as the first two times. When I pulled the needle out, I felt it wasn't going to work, and it didn't. Now I'll have to wait till tomorrow to try it again. Can't really figure out what went wrong, I went a bit higher this time on the penis, about at the half way point. I injected around 2 o'clock, the first two might have been closer to 3, but it should have worked anyway. Trimix users, does this happen to you sometimes? Edit: Ok, about 1/2 hour after injection I did experience a weak erection, weaker than with the smaller doses in my first two injections. What does that mean? I thought you either hit it right, or you don't. Can there be a partial reaction?
 
Last edited:

Online statistics

Members online
7
Guests online
247
Total visitors
254

Latest posts

Back
Top